Alacritech 100x4 Operation & User’s Manual

11, Alacritech 100 Series User’s Guide - Rev 4 3-1 3 Software Installation 3.1 Software Installation Overview This chapter covers the installation of the software required for a 100 Series card. There are different procedures for different types of installations, so take care to follow the co…

5, Alacritech 100 Series User’s Guide - Rev 4 1-1 1 Introduction 1.1 About this Guide This guide describes how to install and operate the Alacritech 100 Series of server adapters on a Windows NT 4.0 machine running Service Pack 4 and above. 1.1.1 Naming conventions Becau…

39, Alacritech 100 Series User’s Guide - Rev 4 5-7 and the performance problems of your system are probably not related to networking (a bottleneck in the disk subsystem for example). Problem Solution Performance improvements of 100 Series adapter are not apparent.  …

41, Alacritech 100 Series User’s Guide - Rev 4 5-9 Problem Solution Point-to-Point Tunneling Protocol (PPTP) does not work through a 100 Series interface.  PPTP connections cannot be established through a SLIC TCP/IP Offload-enabled interfaces. In order to use PPTP …

46, Alacritech 100x4 A-4 Alacritech 100 Series User’s Guide - Rev 4 EXPORT LAWS: You agree that the distribution and export/re-export of the Software is in compliance with the laws, regulations, orders or other restrictions of the U.S. Export Administration Regulations. Some products may contai…

23, Alacritech 100 Series User’s Guide - Rev 4 4-5 Note that while the total amount of data is still 41MB/sec (green line), the same server's CPU is now at around 10% (red line). Also, the data is almost entirely Fastpath (blue line). The percentage of Fastpath data on a healthy n…