Alfa Romeo GIULIA Shop Manual

30, BODY REPAIR REPLACING THE REAR WING ASSEMBLY [ Coupe is shown for example purpose. ) NOTE - To make easier the replacement of the rear wing assembly, the whole replacement unit is available as spare. REMOVAL • Cut off the weld lines to remove the panels as a unit. REINSTALLATION • Position an…

21, BODY REPAIR FRONT CROSS MEMBER REPLACEMENT NOTE - On 1300 and 1600 models (Saloon, Coupe, Spider), when only the cross member requires replacement and the frame alignment checking bench is not available, it is possible to replace the cross member with the special fixture P.N. A.a.Olog f…

2, BODY ALIGNMENT CHECKING BENCH PREPARING THE BENCH AND THE BODY E E • Place the bench on a level floor. • Fit the front and rear screw jacks (do not lock in place those at the rear) and adjust them to the following height from the bench top: - Front: 320 to 330 mm - Rear: 300 mm…

40, Alfa Romeo GIULIA FRONT DOOR LOCKS REMOVAL • Remove the door trim panel and detach the plastic sheet (see page 37). • Loosen the two screws securing the support of remote control handle. • Pry out of its seat the remote control rod guide. REMOVAL AND INSTALLATION DOOR LOCKS 1750 Saloon is show…

29, BODY REPAIR REPLACING THE TAIL PANEL ( Coupe is shown for example purpose. J '----------' REMOVAL • Cut and chip off the seams to remove the tail panel INSTALLATION • Position and secure in place the replacement panel with suitable clamps. • Check that the panel is in prop…