Arctic Cat S2008ACAAAUSG Operator's Manual

82, 78 MAINTENANCE Adjusting Rear Spring Pre-Load Proper adjustment of rear spring pre- load is necessary to get the most com- fortable ride. The chart is designed to help in setting up rear spring pre-load; however, riding style is the single greatest factor in determining rear spri…

47, LUBRICATION 43 9. Install the driven pulley; then install the drive belt (see Drive Belt sub-section) and the belt guard. 10. Install the left-side access panel; the close the access panel. 11. Position the tips of the skis against a wall; then using a shielded safety stand, rais…

23, GENERAL INFORMATION 19 2. Open the air bleed bolt located on the oil pump (beneath the coolant tank) to purge air from the oil hose. ZJ004A  NOTE: When air can no longer be heard, purging from oil pump bleed, tighten the bleed bolt to 1.05 kg-m (7.5 ft-lb). 3. Start the engine. The warning l…

32, 28 GENERAL INFORMATION 0742-499 No special maintenance is required for the reverse transmission; however, if chattering is experienced when the transmission is shifted into reverse, the linkage may have to be adjusted. Arctic Cat recommends taking the snowmobile to an authorized Arc…

93, PREPARATION FOR STORAGE 89 PREPARATION FOR STORAGE Prior to storing the snowmobile, it must be properly serviced to prevent corrosion and component deteriora- tion. An authorized Arctic Cat Snow- mobile dealer should perform this service; however, the owner/ operator can perform this service …

15, Arctic Cat S2008ACAAAUSG GENERAL INFORMATION 11 LOW OIL WARNING LIGHT (Standard 2- Stroke Models) The Low Oil Warning Light is designed to alert the snowmobile operator when the oil in the oil injec- tion reservoir gets below a prescribed level; however, it is highly recom- mended that a visual verification of the…