SuperStick EXP 42" Plus Owner's Manual

12, - 10 - Mounting using SuperStick Pouch Mounting System Step One Insert your print into the SuperStick Mounting & Laminating Pouch. Step Two Place the SuperStick Pouch on the surface of virtually any rigid substrate or foam board – NO ADHESIVE NECESSARY! Step Th…

10, - 8 - Control Panel ( Right ) Figure 1 ( Motor Switch ) - Toggles Laminator Rollers to Forward or Reverse Figure 2 ( Fans Switch ) - Toggles Laminator fans to ON or OFF Figure 3 ( Speed Control Knob ) - Adjusts the speed of the laminator’s heated rollers - Measure…

9, - 14 - Specifications EXP 42” Plus Capacity 41” Height 19 ¼” Width 57” Depth 27 ½” Net Weight 205 lbs. Shipping Weight 255 lbs. Electrical 240V 30A Technical Service: There are no end user serviceable parts in a EXP 42” Plus Laminator! …

7, SuperStick EXP 42" Plus - 16 - Trouble Shooting (Continued) E. CURLING OF THE FINISHED LAMINATION Causes: 1. Unbalanced tension on the supply rolls. Too much tension on the top supply roll will cause the web to curl up. Too much tension on the bottom roll will cause a downward curl in the w…

4, - 2 - Safety Precautions Do not operate laminator with any panels or guards removed. Panels and guards protect operators from such moving parts as the drive chain and sprockets, roller ends, etc. Turn the power switch OFF before walking away or leaving the laminator unattended. Before li…