Banner American Easy-Lam II Operating Instructions Manual

15, 15 ACTION: Ensure all motor switches are in the ON position. Change motor fuse with .75 amp PROBLEM: Laminating film and item being laminated moves through the laminator erratically. ACTION: Check the thickness of the item that is being laminated. Maximum thickness is 1/16” …

14, 14 CAUTION! Do not allow the temperature to exceed 350°F as this could cause the laminating film to melt on the heat shoes, and will void warranty. 3. Adjust the paper guide on the feed table so that the right edge of the item will enter the laminator at the desired position. 4. Pres…

10, Banner American Easy-Lam II 10 1 Pull 6”-12” of film from the top roll. Pass the film under the idler bar and safety shield, and over the heat shoes. Make sure the shiny side of the film is against the shoes. See Figure 5 and 6. 2 For the bottom supply roll, remove the feed table. Place the mandrel …

1, 1 DO NOT DISCARD BOX! (If for any reason you need to ship your machine back and you discard your box you will be responsible for purchasing another one plus any freight charges to ship the box to you) READ BEFORE OPERATING MACHINE FAILURE TO LOAD FILM INCORRECTLY…

5, 5 INTRODUCTION Congratulations on your purchase of the Easy-Lam II Roll Laminator. This unit is designed to provide years of trouble-free service. …