D&K Group EXP 62 Plus Owner's Manual

6, - 5 - Loading Film Step 1: The laminator should be preheated before loading laminating film. To heat the machine see page 6 “Setting Roller Temperature”. Step 2: When the laminator is heating, the rollers should be turning to heat the rubber rollers evenly. Therefore, tur…

7, - 6 - Operation Instructions for Release Liner Rewind (optional) This laminator is equipped with the features necessary to allow the use of pressure sensitive film with release for single side lamination. The Release Liner Rewind will remove the release from the film and win…

19, - 18 - Webbing Diagrams (continued) 3. One Step Decal 4. Two Step Decal Laminator.com www.laminator.com …

8, - 7 - Tension To adjust tension for upper and lower film rolls, the laminator must be loaded and heated. Remove the feed tray. Loosen both tension control knobs by turning counterclockwise until there is no tension on upper or lower film roll. Film should pull freely.…

1, D&K Group EXP 62 Plus EXP 62” Plus Laminator Owner’s Manual REV 01 MADE IN U.S.A. Laminator.com www.laminator.com …

13, - 12 - Mounting and Laminating using a SuperStick® pouch board: 1. Refer to the instruction sheet packed with each box of SuperStick® pouch boards for specific instructions on mounting/laminating with a SuperStick® board. 2. Also, refer to the instruction sheet for information on …