E-FLITE F86 Sabre 15DF Assembly Manual

25, 25E-flite F-86 Sabre 15 DF ARF Assembly Manual  2. Use a #1 Phillips screwdriver to tighten the two 2mm x 8mm sheet metal screws that secure the landing gear strap to the bottom of the wing. The holes for the straps are pre located in the wing.  3. Slide a wheel collar on t…

21, 21E-flite F-86 Sabre 15 DF ARF Assembly Manual  15. Use a hobby knife with a #11 blade to remove the covering 1/32-inch (1mm) inside the line drawn.  16.Use medium CA to glue the control horn to the elevator. Allow the CA to cure before proceeding to the next step. �…

14, 14 E-flite F-86 Sabre 15 DF ARF Assembly Manual  12. Step back about 4–5 feet (1.2–1.5 meters) and view the fuselage from the rear. Check that the stabilizer is in alignment with the wing by checking the stabilizer tips against the wing. Both stabilizer tips should align with…

1, E-FLITE F86 Sabre 15DF Specifications Wingspan: 33.8 in (860mm) Length: 35.4 in (900mm) Wing Area: 256 sq in (16.5 sq dm) Weight w/o Battery: 40–42 oz (1135–1190 g) Weight w/Battery: 53–55 oz (1500–1560 g) F-86 Sabre 15 DF Assembly Manual Pilot not included (PKZ7003) …

24, 24 E-flite F-86 Sabre 15 DF ARF Assembly Manual  10. Slide a pushrod connector on the 19 11 / 16 -inch (500mm) pushrod wire.  11. Insert the pushrod wire into the outside hole of the control horn. Slide the rudder pushrod in the hole of the pushrod connector. Use pliers …

5, 5E-flite F-86 Sabre 15 DF ARF Assembly Manual  4. Lightly sand the aileron servo mount using medium grit sandpaper. This allows the glue to penetrate into the mount and provides a better bond between the mount and wing.  5. Mix a small amount of 6-minute epoxy and …