Maretron DSM150 Operation & User’s Manual

217, Revision 1.4.18 Page 201 Figure 232 – Setting the Barometric Pressure Use the Increase and Decrease buttons to select the correct pressure, and the press the Enter button to store it. 6.31.7 Outside Humidity The Humidity is pre-calibrated before leaving th…

207, Revision 1.4.18 Page 191 6.29 Maretron USB100 Configuration Maretron USB100 gateways on the network may be configured using the DSM150. This describes the configuration of the Maretron USB100 firmware version 1.8.3. The USB100 configuration menu is shown in Figure 21…

66, DSM150 User’s Manual Page 50 Revision 1.4.18 Figure 34 – Setting the Transducer Depth Offset in an Airmar Depth Transducer With the offset value highlighted, you can change the offset by using the Increase and Decrease keys ( or ). Once you have selected the desired offset, p…

139, Revision 1.4.18 Page 123 6.15 Maretron GPS200 Configuration This describes the configuration of the Maretron GPS200 firmware version 3.5.0. The GPS200 has several different programmable parameters that are configurable by the DSM150 display. Normally, it is not necessary to c…

257, Revision 1.4.18 Page 241 A confirmation message is displayed. Figure 278 – Deleting an Alert: Confirmation Press the Accept button to delete the Alert or the Cancel button to return to the previous screen without deleting the Alert. 8.5 Editing an Alert …

198, Maretron DSM150 DSM150 User’s Manual Page 182 Revision 1.4.18 Rectangular Tank – By inputting some dimensions of a rectangular tank, the TLM100 is able to interpolate the volume of liquid from the distance to the surface. 6.25.5.1 Custom Calibration The Custom Calibration setting will pr…