Marine PC MPC-MLR Operation & User’s Manual

19, MPC-MLR-UM(A) 10/2009 19 ONSCREEN DISPLAY The On-Screen Display (OSD) user interface is the path to all display signal source adjustments. The Source Screen Menu, with its user-friendly graphical interface, provides access to ne-tuning the Display. OSD Source Screen Menu Activatio…

28, 28 MPC-MLR-UM(A) 10/2009 Calibration The calibration process aligns the Touch Screen overlay to specic points on the Display screen. 1. Select the Calibration tab or, in ten seconds, the calibration program launches, unless a Multi-monitor situation is present, then go to section…

12, 12 MPC-MLR-UM(A) 10/2009 There are three mounting holes in the back of the Monitor for the ball mounting plate. Take care not to strip the screw holes or over tighten. (Figure 4) • Line up one of the ball mounting plates on these three holes (Figure 4) • With three (3) M4 x 10 counter-su…

10, 10 MPC-MLR-UM(A) 10/2009 SYSTEM SETUP System Requirements The computer the MPC-MLR shall be connected to must have this capability: • Video card setting with a minimum resolution of 640 x 480 pixels, and • If the optional Touch Screen Display is ordered, an available USB or COM port for…

34, 34 MPC-MLR-UM(A) 10/2009 APPENDIX C Technical Specications 8.4” 10.4” 12.1” 15” Display TFT AM, SVGA, LCD, 262K Colors. 800 x 600 pixels  OPTIONAL 1024 x 768 XGA Display  OPTIONAL 1024 x 768 XGA Display 1024 x 768 XGA Display Sunlight Readable Standard…

21, Marine PC MPC-MLR MPC-MLR-UM(A) 10/2009 21 Source Menu Parameters A check in a box indicates an enabled signal source attached to the Monitor. Deselecting the box disables the Monitor’s ability to display the signal. Video 1 - Composite • Open the “Video1“ function, and • Press the UP or DOWN b…