Nel-Tech Labs iLink Installation & User Manual

3, Index: Introduction ........................................................................................................................ iLink Layout Summary..................................................................................................... LCD Layout Summary…

10, Nel-Tech Labs iLink and/or 10 CHANNEL A CHANNEL B IN OUT IN OUT 600Ω ▄ █ MADE IN USA 8Ω ▄ 8Ω 600Ω █ Channel A & B Output Level Adjustments: Step 1: Verify CHANNEL A or B (OUT) is connected to either a phone’s MOH port, PA amplier or speaker. Step 2: Verify the unit is playing audio by list…

7, Web Browser (Feature on rmware version 07.09X or higher) The iLink LCD has a built-in password protected web browser that will display the units serial number, rmware version and MAC address. This browser will also allow the units communication mode, connect-back address and port to be cha…

12, 12 Other LCD Status Messages: Unit is booting: Booting... please wait... Unit is initializing: ilink 07.00.a initializing... Unit is getting ip address: ilink 07.00.a seeking ip... Dealer is connected to unit: DIRECT CONNECT IS ACTIVE Unit is connected to dealer: ACTIVE CALLBACK xxx.xxx.xxx.xxx Fo…

4, iLink Layout Summary: Front of Unit 12VDC - This is where the supplied 12VDC @ 500mA power pack is connected. POWER - Use this switch to turn the unit ON and OFF. LAN - This jack connects to the local Ethernet that allows the iLink connectivity to the Internet. The jack also ha…

11, 11 Channel A & B Input BGM Feedthrough Level Adjustments (Optional): Step 1: Plug feed from an unamplied external background music source to the CHANNEL A or B (IN) and/or CHANNEL A CHANNEL B IN OUT IN OUT 600Ω ▄ █ MADE IN USA 8Ω ▄ 8Ω 600Ω █ Step 2: Verify the unit is playing audi…