WEMPE 20097 Operating Instructions Manual

19, WEMPE digital main clock 20097 Installation and putting into operation V3.0 01/2011 19 3. Set the matching PG screw connection for the cable to be fitted into the cable hole. 4. Insert the cable through the PG screw connection into the terminal box. Make sure tha…

50, WEMPE digital main clock 20097 Annex 50 V3.0 01/2011 1.1.3 Protocol ITRON 2000 Interface RS422/485 Data scope: 1 Start bit 7 Data bit 1 Parity bit (even) 2 Stop bit 4.800 Baud transmission once a second Byte Mark Description 1 STX HE…

8, WEMPE digital main clock 20097 General Information 8 V3.0 01/2011 1.6 Packaging If no arrangements have been made for taking back the packaging, please separate the materials by kind and size for further use or waste recycling. NOTICE! Environmental caretaking! Packaging materia…

17, WEMPE digital main clock 20097 Installation and putting into operation V3.0 01/2011 17 1.3 Installation 1.1.1 Wall mounting 1. Prepare the wall holder according to the drilling template. NOTICE! Size the drill hole diameter for M4 thread screws (e.g…

60, Maritime precision at it’s best! Gerhard D. Wempe KG Division Chronometerwerke Steinstr. 23 20095 Hamburg Germany P: +49 (0) 40 / 33 44 8 – 899 F: +49 (0) 40 / 33 44 8 - 676 E: [email protected] I: www.chronometerwerke-…

29, WEMPE 20097 WEMPE digital main clock 20097 Operation V3.0 01/2011 29 1.1.3 Extension card for analogue clocks If an extension card for analogue clocks is installed in the unit, set the secondary clock line as follows: Two analogue lines are available: LT: local time secondary…