Lexmark X940e Service Manual

386, 3-30 Service Manual 7510 Testing the manual scanner registration Note: Machine must be in Standard User Mode. To properly position the Network Setup Page which will be used as the ADF test original page on the flatbed scanner and the ADF side 1 and ADF side 2, follow the graphic below: Warni…

726, 7-24 MFP Service Manual 7510 Assembly 22: Transfer belt lift 1 Asm- index Part number FRUs/ mach Units/ FRU Description 1 40X3722 1 1 Right transfer belt lift assembly 2 40X3727 1 1 Transfer belt lift handle assembly 3 40X3723 1 1 Transfer belt lift latch assembly with label 4 40X3…

616, 4-208 Service Manual 7510 3X 500-sheet drawer (3TM)—tray module left cover removal 1. Remove the four screws securing the tray module left cover (A). 2. Remove the tray module left cover (A). 3X 500-sheet drawer (3TM)—rear cover removal 1. Remove the four screws securing the r…

369, Diagnostic aids 3-13 7510 Hole Punch Test This test is used to verify that media can be fed to a finisher output bin and then hole punched. No information is printed on the feed test pages. To run the Hole Punch Test: 1. Touch FINISHER TESTS from the Diagnostics Menu. 2. Touch …

243, Diagnostic information 2-129 7510 846.12 Scanner unit assembly software logic error 846.13 Switch (platen interlock) open Step Check Yes No 1 Check the software version for the scanner controller card assembly. Is the version of the software of the scanner controller card assembly correct? Go to …

491, Lexmark X940e Repair information 4-83 7510 7. Remove the switch (transfer belt access door interlock) (A). Laser diode power card assembly removal 1. Remove the rear cover assembly. See “Rear cover assembly removal” on page 4-5. 2. Remove the rear upper cooling fan bracket assembly. See “Rear up…