LabelStation Pro 240 Operation & User’s Manual

41, LabelStation Pro 240 Page 41 of 67 Entering the Manual option displays the following message, with steps which must be completed: Mode Actions Paper Len. 00151 dot 1. Press the DOWN key to move the cursor from left digit to right digit, and press the UP key to set the value from …

50, LabelStation Pro 240 Page 50 of 67 To delete the file use the DOWN button as follows: To run the file (.BAS) use the SELECT button as follows: 3.2.2 Avail. Memory Use this menu to show available memory space. 3.2.3 Del. All Files Use this menu to delete all files. P…

36, LabelStation Pro 240 LabelStation Pro 240 Page 36 of 67 This option is used to adjust print position vertically on the label. The default value is +000 and the range of settings is -120 to +120 dots. Press the DOWN key to move the cursor from left digit to right digit, and press the UP key to set the val…

20, LabelStation Pro 240 Page 20 of 67 2. Refer to chapter 2.6.1 to install the label. 3. Use the DiagTool to set the label sensor type and calibrate the appropriate sensor. Refer to chapter 4. 4. Pull the label through the front of the printer and remove some labels to expose the bare lin…

61, LabelStation Pro 240 Page 61 of 67 The SD Card is inoperable. The SD Card is damaged or not inserted correctly. The card is not of an approved type. Check the card is inserted correctly and/or try it in another device. Check the card’s specification. Poor print quality. Ribbon …