DFI CA63-SC Operation & User’s Manual

33, 2 Hardware Installation 33 2.7.16 PCI Standby Power LED The PCI Standby Power LED will turn red when the system is in the power-on, Soft-Off or Suspend state. Important: Lighted LEDs (red) serve as a reminder that you must power- off the system then turn off the power supplys switch or u…

76, B 76 Troubleshooting Hard Drive Hard disk failure. 1. Make sure the correct drive type for the hard disk drive has been entered in the BIOS. 2. If the system is configured with two hard drives, make sure the bootable (first) hard drive is configured as Master and the second hard drive is…

16, 2 16 Hardware Installation 2.3 Frequency Ratio Settings for Processors The following table shows the available frequency ratios and their corresponding DIP switch setting. There are 4 switches on SW1. The black rectangle in the diagram denotes the part that is protruding, the adjust…

21, 2 Hardware Installation 21 2.7.2 PS/2 Mouse and PS/2 Keyboard Ports The system board is equipped with an onboard PS/2 mouse (Green) and PS/2 keyboard (Purple) ports - both at location CN1 of the ATX double deck ports. The PS/2 mouse port uses IRQ12. If a mouse is not connected to this por…

64, DFI CA63-SC 64 3 Award BIOS Setup Utility 3.1.11 IDE HDD Auto Detection Use this submenu to detect the parameters for the hard disk drives installed in your system. These parameters will then be automatically entered into the "Standard CMOS Setup". The IDE HDD Auto Detection screen displ…

20, 2 20 Hardware Installation 2-3 On: Clear CMOS Data 1-2 On: Normal (default) 123 123 2.6 Jumper Settings for the Onboard Audio Codec Onboard Audio Codec Settings - Jumper JP6 The default setting is 1-2 On, the onboard audio codec enabled. If you are not using the onboard audio code…