DFI P2XBL/D Operation & User’s Manual

42, 3 42 Award BIOS Setup Utility The settings on the screen are for reference only. Your version may not be identical to this one. 3.1.5 PNP/PCI Configuration This section describes configuring the PCI bus system. It covers some very technical items and it is strongly recommended that onl…

44, 3 44 Award BIOS Setup Utility IDE HDD Block Mode Enabled The IDE HDD uses the block mode. The system BIOS will check the hard disk drive for the maximum block size the system can transfer. The block size will depend on the type of hard disk drive. Disabled The IDE HDD uses the standard mode. IDE …

16, 2 16 Hardware Installation 2.6.3 Parallel Ports The system board has a standard printer port for interfacing your PC to a parallel printer. It supports SPP, ECP and EPP modes. You can set the ports mode in the Integrated Peripherals setup of the Award BIOS. 2.6.4 Floppy Disk Control…

28, 3 28 Award BIOS Setup Utility Drive A and Drive B These categories identify the types of floppy disk drives installed. None No floppy drive is installed 360K, 5.25 in. 5-1/4 in. standard drive; 360KB capacity 1.2M, 5.25 in. 5-1/4 in. AT-type high-density drive; 1.2MB capacity 720K, 3.5 in. 3-1/2 in.…

47, DFI P2XBL/D 3 Award BIOS Setup Utility 47 Parallel Port Mode Parallel Por t Mode will appear only if you selected an I/O address and IRQ in the Onboard Parallel Port field. This option applies to a standard specification and will depend on the type and speed of your device. Refer to your peripher…

50, 4 50 Supported Softwares 4.1 Desktop Management Interface (DMI) The system board comes with a DMI built into the BIOS. DMI, along with the appropriately networked software, is designed to make inventory, maintenance and troubleshooting of computer systems easier. With DMI, a network administrat…