Macintosh Performa 5400 Installation Manual

34, 5Unplug the power cord from your computer. You can unplug the power cord now that you discharged static electricity in the previous step. Unplug the power cord from the back of the computer. 34 Chapter 2 …

28, Connecting a PC game controller Some models of the PC Compatibility Card come with a game controller port. To connect a PC game controller, such as a joystick, remove the plastic cover on the game controller port; then plug your game controller into the port. What’s next? Go next to Chapters 4 …

42, 3While supporting the adapter fence with one hand, push the card until it snaps into place. Don’t force the card. If you meet resistance, pull it out and try again. 4 Reinsert the screw into the PC Compatibility card fence and screw it into place. To help insert the screw, push the card fence f…

9, Macintosh Performa 5400 Removing an Apple External Video Connector This section describes how to remove the Apple External Video Connector if there is one installed on your computer. If your computer does not have a video connector installed, skip ahead now to “Installing the Card.” 1Unscrew the jack nut…

8, 10 Place the logic board on a stable, clean, flat surface, and use a thick magazine to prop up one end of the logic board as shown below. The magazine helps protect the components on the bottom of the logic board during the installation. I l l u st r a tion Wo rl d N e w s Vol. 1, …

70, 5Slip the cable clamp over the three folds in the internal PC audio/video assembly cable. Then pinch the open ends of the cable clamp to close it and hold the folds in place. 6Make sure the folded cable lies flat along the top of the card. If necessary, pinch the folds in the cable more to fla…