Diamond Wire Technology CS400 Instruction Manual

28, 25 Table 2 – Tensioner Air Pressures Table 2 – Tensioner Air Pressures Wire Diameter Tensioner Air Pressure Wire Tension (lbs) Wire Tension (N) 0.006” 0.150mm 10 psi 69 Kpa 2.1 lb 9.4 N 0.008” 0.200mm 15 psi 103 Kpa 3.1 lb 13.8 N 0.010” 0.250mm 20 ps…

11, Diamond Wire Technology CS400 8 Press the up arrow to move the yoke upward, and press the down arrow to move the yoke downward. Note the position value moves in the opposite direction. This is because downward yoke movement is considered positive since this is the direction of cut. A quick tap …

1, INSTRUCTION MANUAL Millennium Series Capstan Saws Models CS400, CS410, CT400, CS810 and CT800 Diamond Wire Technology 1605 S. Murray Blvd. Colorado Springs, CO 80916 (719) 570-1150 (719) 570-1176 (FAX) …

27, 24 Use the up and down arrow keys to specify the cutting gap, or distance between the inside edges of the two guide pulleys. When ready, press the right arrow key to proceed. At this screen you are being asked to confirm that the wire is straight between the guide pulleys. …

26, 23 The sensor is adjusted and calibrated at the factory, but could require adjustment and/or calibration if the sensor bracket is bent or moved, or pulley wear/replacement changes its relative position to the wire. At no time should the cutting wire be in direct contact wit…