Maco Antennas VQ2-QUAD Assembly Instructions Manual

3, MAC0 VQ2 QUAD REFLECTOR WIRE DIRECTOR WIRE ASSEMBLY ASSEMBLY A\ \ (SEE FIG. 5) ELEMENT ASSEME (SEE FIG. 3) ELEMENT-TO-BOOM GAMMA MATCH MOUN MOUNTING (SEE FIG. 6) (SEE FIG. 7) DIRECTION OF RADIATION BOOM-TO-MAST MOUNTING (SEE FIG. 7) FIGURE 1 GENERAL ASSEMBLY INSTRUCTIONS This figure…

1, ® VQ2-QUAD MACO Antennas, A Division of Charles Electronics, LLC 302 S. East Street, Mt. Carroll, IL 61053 Copyright © 2009 Charles Electronics LLC • All Rights Reserved www.macoantennas.net (815) 244-3500 …

6, ZOIP \ * NOTE:THESE DIMENSONS ARE AP- PROXIMATE. REFER TO THE MSTRUC- TIONS ON ADJUSTINNG THE S.W.R. TO DETERMINE EXACT SETTINGS. THERE ARE 2 SEPARATE GAMMA ADJUSTMENTS, 1. CAPACITOR ADJUSTMENT, 2. SLIDER POSITION. DO NOT MOVE BOTH AT THE SAME TIME. MOVE THE CAPACITOR FIRST, THEN, IFNEC…

7, -------- _---- _----- _---P-e --------\ I I 112” O.D. MAST i NOI, N02, / PO3P 02 OF (CUSTOMER FURNISHED) BOOM WITH ATTACHED ‘so2 I (Figure 7A) (Figure 7B) I this antenna is designed for mounting on a 1 l/2” O.D. I Mark the center of the boom and attach the boom-to-mast 1 plate…

9, Maco Antennas VQ2-QUAD Installing and rigging towers, masts and antennas require specialized skills and experience. Information supplied by M ACO assumes that all products will be installed by personnel having these skills and have installed similar products before. No one should attempt to install towers or masts wit…

8, /-- -------------------__----------------- -- \ I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I 10 METER ASSEMBLY INSTRUCTIONS ELEMENT ASSEMBLY ,n. ‘I\ \mgure 3) (OPTIONAL) - 4” + n 12’ - 7-l/2” (Figure 4A) PLll, FOI P \ I I-l 6’ 6-l 12” …