Digital Alert Systems DASDEC-1EN Quick Start Manual

19, Digital Alert Systems DASDEC-1EN Quick Start Guide for Your DASDEC II Page 19 of 40 3) On the “Setup > Time” page set your time zone (circled in red) and then click the “Submit Date/Time/Time zone Changes” button (circled in blue). Under the heading Network Time Protocol on this page is where yo…

35, Quick Start Guide for Your DASDEC II Page 35 of 40 Step 9 – GPIO Configuration The DASDEC-II ships with two General Purpose Inputs and two general purpose outputs, depending upon your hardware configuration your DASDEC-II may have additional GPIO inputs and outputs. Th…

30, Quick Start Guide for Your DASDEC II Page 30 of 40 Step 8 – Set-up Station Interface and Required Tests After the DASDEC-II’s Base Station configuration has been completed you can begin to configure a “Station Interface” for each station. Station Interface Con…

22, Quick Start Guide for Your DASDEC II Page 22 of 40 Step 6 – Alert Decoding, Filtering & Forwarding By default the DASDEC-II monitors for all alerts sent to all areas and will make all of those alerts available for forwarding. Changing the alert filters for will af…

13, Quick Start Guide for Your DASDEC II Page 13 of 40 MPEG Encoder If you have purchased the DVS-168 or DVS-644 options see section 4.10.1 and 4.10.4 of the Manual for details. If you’ve purchased the MPEG2 option you can also refer to section 2.6 and 4.10.4…

14, Quick Start Guide for Your DASDEC II Page 14 of 40 2) After logging in Click on the “Setup” tab (circled in red), then click on the “Audio” radio button (circled in green) and then click on the tab “Radio Tuners” (circled in blue). …