MakerBot Botmobile Dune Buggy 2013 Assembly Manual

28, B O T M O B I L E 26 Experimental Stuff Tires: Pyrophreek requested a model for suitable tires for the care in order to print those in polyurethane rubber. The, so far, untested version of the tires is not available for download (EXPERIMENTAL_Botmobile Tire_Rubber.…

3, MakerBot Botmobile Dune Buggy 2013 B O T M O B I L E 1 Tools & Part List ollowing tools and components are required to fully assemble the Makerbot Botmobile 2013. I have indicated the components which I have personally tested with this design. Although I can’t guarantee it the other variants listed should …

7, B O T M O B I L E 5 Printing the parts hen I printed the 2 prototypes after modifying the Makerbot original plans I used exclusively ABS material only. Although the Botmobile should print fine in PLA, I can’t guarantee that the gears will last given the friction and resultin…

11, B O T M O B I L E 9 Attach the swing arms to the control arm Attach the swing arms and control arm assembled in the previous step to the steering base. Attach the steering top mount/servo holder to the assembly as shown above. …

20, B O T M O B I L E 18 Slide the interior into the body shell (from rear to front) and press it in place. Secure the interior in place with the M3x7 screw Align the steering assembly and route the servo cable through the gap as shown above …

24, B O T M O B I L E 22 Final assembly and RC installation Slide the LiPo into the battery mount and route the cables. A cable tie can be used to fix the ESC side of the battery connector to the motor leads. The LiPo cable can then be plugged directly into the ESC connecto…