TracVision M7 Installation Manual

40, 41 Cetrek Format Communication: 4800 baud, 1 start bit, 8 data bits, 1 stop bit, no parity Update rate: 1-20 Hz, selectable Sentence type: $$MSB LSB B C Status D<cr><lf> MSB LSB Binary value 0-1023, equal to 0.0- 359.6 degrees stabilized magnetic heading B ASCII hex 0x00 C ASCII he…

17, 17 In Step 4, you identified a suitable ADCU mounting location. Now follow these steps to mount the ADCU using one of the following options: Option 1 - Velcro mount to a horizontal surface Option 2 - Flush mount to a vertical surface Option 1 - Velcro Mount a. Clean and dry the bottom of the…

16, 16 Follow these steps to connect power to the antenna and ADCU. a. Before you begin, disconnect vessel power. b. Connect the power cable from the antenna to 12 VDC (4 amps continuous) vessel power via a dedicated 10-amp circuit breaker (see Figure 27). c. Connect an additional powe…

7, TracVision M7 7 Once you have identified a suitable antenna mounting site, according to the guidelines provided on page 4, follow these steps to drill the mounting holes and cable access hole to prepare the site for installation. a. Unfold the antenna mounting template (supplied in the Cust…

49, 51 8.87" (225 mm) 7.62" (194 mm) .63" (16 mm) 3.08" (78 mm) 1.83" (46 mm) .63" (16 mm) 4x .136" (3.45 mm) 4x R .63" (16 mm) ADCU Flush Mounting Template …

11, 11 In Step 3, you identified a suitable GyroTrac sensor mounting location. Now follow these steps to mount the GyroTrac using one of the following options: Option 1 - Mount to a horizontal surface Option 2 - Mount to a vertical surface Option 1 - Mount to a Horizontal Surface a…