Ski-Doo MX Operator's Manual

22, Ski-Doo MX PRE-START CHECK ______ _ Check Points • ACTIVATE THE THROTTLE CONTROL LEVER SEVERAL TIMES to check that it operates easily and smoothly. The throttle control lever must return to idle position when released. • Check that the skis and the track are n…

29, N -...,J )> ~ 0 NOTE: There are nine (9) grease fittings on track suspension. Lubricate track suspension lowing grease fittings: fol- front arm: upper and lower axle front swing arm: upper and lower axle - front shackles -rear arm: upper and lower…

38, Alignment Start the engine and accelerate just so that track turns slowly. Check that the track is well centered; equal distance on both sides between edges of track guides and slider shoes. (TYPICAL) Equal distance A014 005 022 Guides Slider shoes A001 005 00…

14, +ON +OFF ~~ position Lower position starting to stop engine A017 006 004 The driver of this vehicle should famil- iarize himself with the function of this device by using it several times on first outing. Thereby being mentally prepar- ed for emergency situations re…

34, Squeeze firmly AOOS 006 002 After the adjustment, brake should apply fully when lever is approximately 13 mm ( 112 in) from handlebar grip. If not do not tamper with the brake, contact your servicing dealer. 13 mm (112 in) A008 006 002 Spark Plugs Discon…

35, Shock Absorber Spring Adjustment Driver's weight Surface condition A015 005 041 Each shock absorber has a five (5) po- sition cam located at the bottom of the shock. Spring preload may be increased or decreased by turning the cam. To adjust, use the adjustment k…