Standard Horizon CP590 Owner's Manual

92, CP590 Page 93 WAAS 3D 1 2 3 Figure 12.4 - Celestial page Refer to the image above. The time (1) displayed corresponds to the location of the cross- hair cursor (3) in the Tide Graph (2). Moving the ShuttlePoint knob to the left or right changes the time, moving the ShuttlePoint knob up or down sele…

37, Page 38 CP590 1. Press [INFO]. 2. Move the ShuttlePoint knob to highlight WRECKS and press [ENT] or move the ShuttlePoint knob to the right. 3. A popup window will be shown with a list of nearest Wrecks. 4. Move the ShuttlePoint knob to highlight the desired Wreck and press [ENT]. 5. …

32, CP590 Page 33 CURSOR WINDOW By default when the cursor is moved a window is shown with the Lat/Lon Distance and Bearing from the vessels location to the cursor. This selection allows the window to be turned On (default) or Off. The Cursor Window is automatically disabled when Gen…

109, Page 110 CP590 Area of coverage of downloaded data is located by default with its center on the cursor position Indicates the LAT/LON position of the cursor Cursor is locked to the gray area. Moving the cursor also moves the gray area allowing locating it over the area where the use…

35, Standard Horizon CP590 Page 36 CP590 WAAS 3D WAAS 3D Figure 4.0.0a - Find Port Services 4.0.1 Port This feature is used to locate the 10 nearest Ports to the position of your vessel. A Port is represented with a on the Chart Page. 1. Press [INFO]. 2. Move the ShuttlePoint knob to highlight PORT and pre…

132, CP590 Page 133 Spot Soundings ........................................................... 46 spot soundings ............................................................ 45 Standard (Zoom Type) ................................................ 49 Standard Zoom .......................................…