Starkey RIC Operation Manual

7, Starkey RIC 12 13 PreparationPreparation Helpful Hints • NEVER FORCE THE BATTERY DOOR SHUT. This could result in serious damage. If the door will not close securely, check that the battery is inserted correctly. • Do not open the battery door too far or damage is likely to occur. • Dispose …

21, 40 41 FDA InformationFDA Information Required Information The following additional information is provided in compliance with U.S. Food and Drug Administration (FDA) regulations: WARNING TO HEARING AID DISPENSERS. A hearing aid dispenser should advise a prospective hearing aid user to consul…

16, 30 31 Hearing System CareHearing System Care Standard Tubing (BTE ONLY) 1. Separate the Custom Earmold from the BTE by gently pulling the tubing away from the earhook (Fig. 1). • Use a soft, damp cloth or a cleaning brush to clean debris from the Custom Earmold • Wash the…

18, 34 35 Tips for Better CommunicationHearing System Care Troubleshooting Guide SYMPTOM POSSIBLE CAUSES SOLUTIONS Not Loud Enough Low battery Replace battery Blocked earmold/tubing/ earbud Clean or replace wax guard as needed Hearing change Contact your hearing care professional…

23, 44 45 FCC InformationFCC Information REGULATORY NOTICES RIC 13 FCC ID: EOA-24HALOXF13 IC ID: 6903A-24HALOXF13 BTE 13 FCC ID: EOA-24HALOBTE13 IC ID: 6903A-24HALOBTE13 FCC NOTICE This device complies with part 15 of the FCC rules and with RSS-210. Operation is subject to the followin…

9, 16 17 PreparationPreparation BTE 13 Insertion and Removal To insert the Custom Earmold: 1. Hold the Custom Earmold with your thumb and forefinger on the outer side near the tubing (Fig. 1). 2. Tilt your hand slightly forward and gently insert the canal tip of the Custom Earmold into …