Storm AXS Strike Master Manual 

1, DES-MAN ISS.3 Page Section Contents 1 i) Introduction and Factory Defaults 2 ii) Installation Instructions iii) Electrical and Data Connections; Circuit Schematic 3 iv) Code Entry Mode v) Programming Mode 4 vi) Adding and Removing Codes 5 vii) Changing Door Strike Times viii) Setting the Invalid …

6, Start new command sequence Enter to d 1 8 LOG OFF? Enter d 0 YES SETTING THE ALARM / SECOND DOOR OPTION Alarm Second Door Control To select Alarm or Second Door option Enter d 0 Enter d 8 Enter d 1 a) The Remote Exit / Egress Switch Making a connection (via a suitable mom…

8, Storm AXS Strike Master 8 (Detailed explanation of command sequences are located in sections v) to ix). DES-MAN ISS.3 Whilst every effort is made to ensure that information given in this document is correct at time of print, Keymat Technology Ltd. can not be held responsible for any errors contained within. STOR…

3, Start new command sequence Enter to d 1 8 Enter new 6 digit Engineer's Code Enter d To select new Engineer's Code Enter d Enter Engineer's Code If code is not known 'Power Down' then Power Up LOG OFF? X X X X X X Enter to log on 7 2 5 4 0 0 X X X X X X …

4, Notes: a). Entry Codes should not start with numbers 9 or 1. b). Each entry code recognised by the keypad is stored under a two digit reference known as the Code Index Number . The code index number allows an authorised holder of the engineer’s code to remove entry codes by keying in the c…

2, Fixing Instructions (Please read carefully before attempting installation.) Rear Casing 1. Select a suitable location with a sound flat surface. Using the case as a template, mark the position of the four fixing holes (A) on the surface. 2. Drill and plug the fixing holes to suit fixi…