Subaru Impreza 2004 Service Manual

44, 5MT-113 MANUAL TRANSMISSION AND DIFFERENTIAL Shifter Fork and Rod NOTE: Apply a coat of grease to plunger to prevent it from falling. 6) Install the 3-4 fork rod into 3-4 shifter fork via the hole on the rear of transmission case. 7) Align the holes in rod and fork, and new drive straight pin in…

5, 5MT-74 MANUAL TRANSMISSION AND DIFFERENTIAL Main Shaft Assembly for Single-Range 3) Remove the insert stopper plate, sleeve and hub assembly No. 2, baulk ring, 5th drive gear and nee- dle bearing. 4) Using ST1, ST2 and a press, remove the rest of parts. NOTE: Replace sleeve and hub with o…

26, 5MT-95 MANUAL TRANSMISSION AND DIFFERENTIAL Drive Pinion Shaft Assembly D: ASSEMBLY 1. AWD MODEL 1) Install the sleeve and hub assembly by matching alignment marks. NOTE: Use a new gear and hub assembly, if gear or hub have been replaced. 2) Install the washer, snap ring and sub gear to 1…

14, Subaru Impreza 2004 5MT-83 MANUAL TRANSMISSION AND DIFFERENTIAL Main Shaft Assembly for Dual-Range • Do not reuse the ball bearing. ST1 499757002 INSTALLER ST2 498077400 SYNCHRO CONE REMOV- ER 6) Using the ST1 and ST2, remove rest of the parts. NOTE: Replace the sleeve and hub with new ones. Do not attempt to disas…

43, 5MT-112 MANUAL TRANSMISSION AND DIFFERENTIAL Shifter Fork and Rod 23.Shifter Fork and Rod A: REMOVAL 1) Remove the manual transmission assembly from vehicle. <Ref. to 5MT-38, REMOVAL, Manual Transmission Assembly.> 2) Remove the back-up light switch and neutral po- sition switch. <Ref. to 5…

7, 5MT-76 MANUAL TRANSMISSION AND DIFFERENTIAL Main Shaft Assembly for Single-Range 9) Install the synchro cone stopper and snap ring to 5th-Rev sleeve and hub assembly. 10) Install rest of the parts to the rear section of transmission main shaft. NOTE: Align the groove in baulk ring with shif…