Sun Oracle Sun SPARC Enterprise T5140 Administration Manual

56, Sun Oracle Sun SPARC Enterprise T5140 Handling Faults 45 2. At the ILOM -> prompt, type: The system is set to run full POST diagnostics on system reset. 3. To return to your normal diagnostic settings after running POST, type: Related Information ■ “Discover Faults Using ILOM” on page 44 ■ “Locate the System” on page …

2, Please Recycle Copyright © 2008, 2010 Oracle and/or its affiliates. All rights reserved. FUJITSU LIMITED provided technical input and review on portions of this material. Oracle and/or its affiliates and Fujitsu Limited each own or control intellectual property rights relating to produ…

46, Managing Disks 35 Related Information ■ “Disk Slot Numbers” on page 35 ■ “Hot-Plug a Mirrored Disk” on page 28 Disk Slot Numbers To perform a disk hot-plug procedure, you must know the physical or logical device name for the drive that you want to install or remove. If your system enco…

32, Managing Disks 21 2. Type the following command: The creation of the RAID volume is interactive, by default. For example: When you create a RAID striped volume, the other member drives (in this case, c1t2d0 and c1t3d0) disappear from the Solaris device tree. As an alternative, you can use the �…

44, Managing Disks 33 4. Verify that the device has been removed from the device tree. Type the following command: Note that c1t3d0 is now unknown and unconfigured. The corresponding hard drive OK-to-Remove LED is lit. 5. Remove the hard drive, as described in your server’s service manual. The blue…

33, 22 Sun SPARC Enterprise T5140 and T5240 Servers Administration Guide • December 2010 4. To check the status of a RAID striped volume, type the following command: The example shows that the RAID striped volume is online and functioning. Under RAID 0 (disk striping), there is no replication of data …