Etdoor ET-600E Installation Instructions And User Manual

6, Installation(aluminum track) 5) Photo beam (RX/TX Type) Before attaching the U brackets (E) (Fig. 4) screw an inverted nut (6mm) (D) on each stud then position the brackets (E) on the studs and secure them in-place using a second 6mm-nut and then lock the brackets to the rail by tighteni…

15, Etdoor ET-600E Manual disengagement The opener is equipped with a manual release cord to disengage shuttle and move door by hand while holding the handle down (Fig 16). Pull on the handle to disengage the shuttle. To re-engage the door simply run opener in automatic mode or move door by hand until the tr…

16, Final notes This manual is only used by technical persons who are qualified to carry out the installation. No given information in this manual can be considered of any interest to the end user. It is important for the installer to show their clients correct operation using of the opener includin…

2, CONTENTS Important safety recommendations...…………………………….……………………………..1 Basic function introduction………………………………………………………………………..2 Special function introduction……………………………�…

17, Technical specifications Model ET-600E ET-800E ET-1000E Power Input: 200-240V AC 50/60Hz 200-240V AC 50/60Hz 200-240V AC 50/60Hz Output power: 150W 235W 245W Max force: 600N 800N 1000N Open/Close speed: 0.15m/s 0.15m/s 0.15m/s Lamp: LED，24V DC LED，24V DC LED，24V DC Light time: 3 mi…

9, Fig. 10 Fig. 11 1. As Fig.7, slide the end rail into the 1st sleeve, slide the middle rail into the 1st sleeve; 2. As Fig.8, slide the 2nd sleeve to the other end of middle rail, slide the top rail into the 2nd sleeve; 3. Remove the plastic film on the end rail , cut the plastic cab…