Midas PRO6 Quick Reference Manual

47, Saving your work 33 PRO6 Control Centre Quick Reference Guide Saving your work We recommend that you save your work regularly while carrying out the procedures included in this chapter. Not only is this good practise during normal PRO6 operation, but in this instance it may save…

76, 62 Chapter 7: Setting Up The System PRO6 Control Centre Quick Reference Guide Switching the PRO6 Control Centre on/off Carry out the following to switch the PRO6 Control Centre on or off in a safe manner, observing all WARNINGS and Cautions. >> To switch on the PRO6 Control Centr…

57, Setting up a mix 43 PRO6 Control Centre Quick Reference Guide 4 In the mix (upper) section, do the following: • Press PRE to select pre-fader (on) or post-fader (off). Button status is only available on the GUI (see Figure 10 on page 41). • Press ON to route the aux mix from input to aux o…

51, Input dynamics processing (D zone) 37 PRO6 Control Centre Quick Reference Guide Input dynamics processing (D zone) Set up compressor and gate dynamics processors using the controls in the input channel strip’s D zone. There are four compressors available, corrective, adaptive, c…

54, 40 Chapter 6: Basic Operation PRO6 Control Centre Quick Reference Guide >> To assign output channels to a VCA/POP group Use the method shown in “To assign input channels to a VCA/POP group” on page 39, but to select a group member press the quick access button of the outpu…