Brickcom OB-100A Quick Installation Manual

14, 4 Water Proof Connector Refer to the installation guide included in the package when installing the Water Proof connector 4.1 Insert the stripped cable through the sealing nut and the housing. Clamp the cable with an RJ45 plug. 4.2 Push the RJ45 plug into …

10, 2 Wall Installation Using the Optional Bracket 2.1 Using the Bracket plate as a guide, drill three holes into the wall and hammer the supplied plastic anchors into the three holes. Use a screwdriver and the supplied screws to secure the plate to the wall. 2.2 Atta…

17, 4. Setup the Network Camera 1. Insert the Installation CD into the CD-ROM driver. Run Auto-Run Tool directly from the CD-ROM to start the installation. When installing the Brickcom software kit for the first time, select a desired language for the interface. …

25, 7. When the IP address settings have been configured, the screen will either display a successful or failed connection message. If the connection failed, either try again or quit the installation. a. If “DHCP IP address settings” was selected, the failure page …

5, Brickcom OB-100A B. Wi-Fi Antenna Package contents (optional) Refer to the installation guide included in the package when installing the Wi-Fi antenna. a. Wi-Fi Dual Band Antenna b. Extension Cable c. Surge Arrestor Kit d. Mount Kit C. 3G Ante…

2, Read Before You Use 1. Power off the camera device immediately if it starts smoking or smells unusual. 2. Power off the camera device immediately if the camera is exposed to rain or liquid. 3. Do not set the camera device near …