MIMAKI JV5-130S Operation Manual

83, 3-13 Setting the media on the printer 11Hold the medium with the media press gently. 12Set a free paper tube on the take-up device. 13Adjust the level adjusters of the take-up device so that the bottom of each of them rests on the floor and secure them by tightening the thumb screws.  …

195, 5-7 If image quality is poor 4 Remove the ink cartridges. Ink is discharged to the waste ink tank. 5 When the display shown below appears, set the cleaning liquid cartridge in the ink station. Cleaning liquid is drawn up. 6 When the display shown below appears, remove the cleaning liquid ca…

85, MIMAKI JV5-130S 3-15 Setting the media on the printer When the media thickness cannot be detected There may be a case where the media thickness cannot be detected properly depending on the media. In such a case, the media thickness must be input manually. STEPS: 1 An error is displayed, and the carriage returns to …

43, 2-7 Configurations and Functions When water-based ink is used K Black M Magenta C or BL Cyan or Blue Y Yellow Lc or LBL Light Cyan or Light Blue Lm Light Magenta Lk Light Black 4 color ink set Four ink cartridges for each color. 6 color ink set Two ink cartridge for each of K, Y, Lc (LBL) and Lm …

50, 2 Before Use 2-14 Operation Panel Use the operation panel to make settings for printing or operate the printer. The operation panel is equipped with one lamps (a) to indicate the status of the printer, two displays (b), eight keys (c) to be used for various operations, seven direct…