AtVideo IPVDD1TW Instruction Manual

22, 4. PRI VACY -. AREA SELECT: Select MAK area number. -. AREA DISPLAY: Select MASK ON/OFF. -. LEFT/RIGHT: Adjust the location of the MASK area with boundary LEFT and RIGHT. -. WIDTH: Adjust width of MASK area. -. TOP/BOTTOM: Adjust the location of the MASK area with boundary TOP…

11, Optional Heater Kit Installation 1. Pl ace the heater element is slot “A”. Please ensure that the cables are facing upwards and the heater is pointing towards the Dome. 2. Place the PCB in slot “B”. Please ensure that the PCB is facing inside of the Dome with the conn…

68, AtVideo IPVDD1TW 68 3.10 Resetting to the factory default settings To reset the Network Camera to the original factory settings, go to the Setup > System > Maintenance web page (described in “3.6.5.6 Maintenance”) or use the control button on the network camera, as described below: •…

39, ▼ Motion Motion detection is used to generate an alarm whenever movement occurs (or stops) in the video image. A total of 8 Motion and/or Mask windows can be created and configured. Motion is detected in defined Motion windows, which are placed in the video image to targe…

67, 3.9 Help The Help inf ormation window will be provided as a popup window so that users can open and read it without a need for log-in. It will offer a description on setting and Help page by which users can manipulate the Network Camera without a reference to the manual. …

44, • HT TP Server Test When the setup is complete, the connection can be tested by clicking the Test button. ▼ Alarm Out When the network camera detects an event, it can control external equipment connected to its alarm output port. Check the box to enable and then select ei…