Mod THUNDERDRIVE (K-950) Instruction Manual

4, PARTS LIST 2 4 0.1µF Capacitor 50V C-PFD1-50-R (2) yellow violet red gold 4.7K 4.7kΩ Resistor ½ W R-A4D7K (1) red black green gold 2M R-A2M (1) 2MΩ Resistor ½ W P-QMPSA18 (1) NPN BJT (MPSA18) MPS A18 E B C 1N4148 HIGH SPEED SOLID STATE DIODE P-Q971 (2) 104J S-G312 Insulating Tolex…

5, SOLDERING TIPS 1. Bend the component lead and wrap it around the connection point. 2. Wrap the component lead so that it can hold itself to the connection point. 3. Heat up both component lead and connection point with the soldering iron. 4. Apply solder to both component lea…

2, TABLE OF CONTENTS TOOL LIST …………………………………………………………………………...2 PARTS LIST DRAWINGS………………………………………………………….3, 4 SOLDERING TIPS ……………………………………………………………�…

1, 1 Copyright © 2011 by modkitsdiy.com Use these instructions to learn: How to build an effects pedal for overdrive. The Thunderdrive is an overdrive pedal kit that will provide a strong clean signal boost in the early gain settings and smooth distortion at maximum gain settings. Adjusting…

6, Mod THUNDERDRIVE (K-950) SECTION 1 – Mount ¼” Jacks and Terminal Strip Components Please refer to DRAWING 1 and DRAWING 2. Orient the box with ½” hole nearest you. Mount input jack in 3/8" hole on left side of box with hardware provided. Mount output jack in 3/8" hole on right side of box with hardware …