Consew 206RBL Instruction Manual

6, 4-4. Installing the spool pin ( 4. INSTAllATION Insert the spool pin 0 into the installation hole. and screw it in tightly. 4-5. Installing the knee lifter assembly - 4 - 1. Assemble the knee lifter assembly 0as shown in the illustration. NOTE: Make sure that the knee lifter stopper. is facing …

20, 8-7. Adjusting the timing between the needle and the hook After setting the needle bar height, set stitch length to minimum, turn the machine pulley toward you until the needle bar reaches its lowest point. Continue turning and allow the needle bar to raise about 2mm while on its up- ward stroke.…

21, 8. STANDARD ADJUSTMENTS 8-8. Adjusting the Clearance between rotary hook and opener (Thread release finger) The opener facilitates the passage of the needle thread loop by slightly nudging the inner hook creating a slight rotating movement of it. This movement at that very instant op…

9, 4. INSTALLATION 4-10. Lubrication A CAUTION 1 Do not connect the power cord until lubrication has been completed, otherwise the machine may operate if the treadle is pressed by mistake, which could result in injury. Be sure to wear protective goggles and gloves when handling the lubricating oi…

12, Consew 206RBL * * 5. PREPARATION BEFORE SEWING 5-3. Winding the lower thread , A CAUTION A • Do not touch any of the moving parts or place any objects against the machine while winding the~ lower thread, as this may result in personal injury or damage to the machine. 1. Turn on the power swit…

26, 9. SAFETY CLUCH MECHANISM 9. SAFETY CLUCH MECHANISM If the thread is tangled with the rotary hook during sewing, the safety clutch mechanism for the safety clutch pulley operates to stop the lower shaft and let the safety clutch pulley race off load, thereby protecting the rotary h…