Tandberg Data LTO-5 Operation & User’s Manual

23, Figure 2-3 Installing a full-height tape drive Figure 2-4 Installing a half-height tape drive The illustration shows a server that uses mounting rails. If your server does not use mounting hardware, check that Note: the holes in the chassis are aligned with the holes in the side of the tape drive.…

49, Tandberg Data LTO-5 6 Operating your tape drive In this chapter: • “Loading a cartridge” on page 50 • “Unloading a cartridge” on page 51 • “Removing power from the drive” on page 52 49 # May 2010 …

19, 2 Installing an internal LTO tape drive If you are installing an external LTO tape drive, please refer to “Installing an external tape drive” on page 37. Always refer to http://www.tandbergdata.com to find out which HBAs and cables are appropriate for your combination of server and tape drive.…

44, 5. Drive Error LED 1. On/Off switch (external drives only) 6. Tape Error LED2. Eject button 7. Clean LED3. Reset 4. Ready LED Figure 5-2 Front view of full-height LTO–4 external tape drive Front view of half-height LTO tape drive with LEDs 5. Tape LED1. Cassette door 6. Drive LED 2. On/Off sw…

31, 2. Change the tape drive's SCSI ID, if necessary. The SCSI ID is set using jumpers on a set of pins at the rear of the drive, as illustrated. Use tweezers or small pliers to move the jumpers to the pattern corresponding to the ID you want. Do not remove the TP jumper. It shoul…

11, 1 Before you start In this chapter: • “Supported models” on page 11 • “Which operating systems are supported?” on page 11 • “How do I connect the drive to my server?” on page 12 • “Your LTO tape drive” on page 15 • “Power specifications” on page 16 • “Driv…