NotifEye Wireless Sensors and Ethernet Gateway Manual 

12, 12 Contents Page Mounting Sensors Sensors should be placed on a clean, dry, at surface. Place them at least 3 ft away from each other and any wireless gateway for clearest transmissions. Do not place the sensor body inside any refrigerator/freezer cabinet or storage area since …

1, NotifEye Wireless Sensors and Ethernet Gateway N TIF EYE POWERED BY TEMPTRAK TM NotifEye ™ Wireless Sensors and Ethernet Gateway Manual Inside the Box • (4) Temperature Sensors #15100 • (1) Ethernet Gateway #15501 Power Supply Cord Antenna 6 ft Ethernet Cable • (4) CR2032 Coin Cell Batteries • (4) Loop & Lock T…

17, 17 Contents Page User Information For detailed instructional videos on how to use your NotifEye™ Wireless Sensors or the NotifEye™ Online System, please visit us at: www.cooper-atkins.com/notifeye/support This equipment has been tested and found to comply with the limits for a Class …

3, 3 Contents Page Setting Up the Hardware Setting Up and Using the Ethernet Gateway • Connect the antenna. • Plug the Ethernet cable with internet connectivity into the gateway. • Plug the power supply cord into a power outlet then connect the plug into the gateway. • Once…

9, 9 Contents Page Threshold Buffer A buffer to prevent the sensor from bouncing between standard operation and the aware state when the assessments are very close to a threshold. E.g., if a minimum value is set to 32°, a maximum value is set for 41° and the buffer is set to 1°, when a sen…

5, 5 Contents Page • Press the “Assign Sensor” button. The sensor will now appear in the sensor list. • Repeat this process to add more sensors to this network. Note: Sensors contain initial factory data that should be cleared before collecting new data. To do this, click t…