Tech One 02A-703 Metis Assembly Manual

4, Use some C/A to glue the two carbon strip (73 and 79.2 cm long) on both sides of the win g as sh ow n in the picture. NOTE: position the wing on a flat surface. Fix the elevator with 3M tape.Do the same with ailerons. 4 Cut a 55º bevel on ailerons. On elevator and rudder cut a 40° be…

8, Use so me C/A to fix the rudder servo in the pre-reserved slot on the upper vert- ical fuselage as shown in the picture. Use some C/A to fix the two aileron serv- os in the pre-reserved slots on the down- side vertical winglets as shown in the picture. Use some C/A to fix the elevator servo in…

5, Tech One 02A-703 Metis Insert the downside vertical winglets into the pre-reser ved slots on the do- w n s i d e o f t h e w i n g a n d a p p l y some C/A to fix. Inser t the par ts to reinforce contr ol surfaces into the pre-reser ved slots on ailerons and apply some C/A to fix. Fix with C/A the two…

7, Install the landing gear. Please inser t through the pre-reserved holes on the fuselage and wing the two 2 mm x 24 cm carbon rods, then use C/A to fix. Fix with C/A the three 1 mm carbon rods as shown in the pictures. Fix with C/A the 0.8 mm carbon rods to reinforce the ailerons.…

11, 2 11 Use sm all piece s of velcro to fix the ESC, receiver and batter y. NOTE: you can adjust the place of battery acco- rding to the CG position. A perfect Metis is done after your car- eful assembly. While assembly, the fl- ying weight is really critical to the fli- ght perfor mance and will be …