Teseo CBA 3G-100 Operation & User’s Manual

6, 6 CBA 3G-100 This apparatus is capable of delivering harmful levels of radio frequency power. Ensure at all times during opera- tion that the RF output is properly terminated with an adequately rated termination or transducer, and that the cables and connectors attached to the …

8, 8 CBA 3G-100 Threat Precaution Exposure of personnel to high RF elds produced by an antenna con- nected to the output of the ampli- er. Ensure that the antenna is inside a screened enclosure and t an interlock to the entry door to prevent access while the amplier is operating. RF…

11, 11Air inlet The amplier depends upon a free air supply for cooling. Ensure that the front air inlet is not restricted. 4.2 Rear panel Mains input The mains input is an IEC 60320 type. The cable attached to the mains input must be rated at 10 A to ensure proper operation at the m…

7, Teseo CBA 3G-100 7 CBA 3G-100 introduction The CBA 3G-100 is an amplier capable of supplying 100 W into a 50 ohm load over the frequency range 800 MHz to 3.1 GHz, during the course of EMC tests on electrical equipment. The amplier is designed with sufcient gain such that it may be used with normal output…

16, 16 To nd your local partner within Teseq ® ’s global network, please go to www.teseq.com © December 2010 Teseq ® Specications subject to change without notice. Teseq ® is an ISO- registered company. Its products are designed and manufactured under the strict…