Robe CitySource 96 Operation & User’s Manual

17, CitySource 96 (Single colour) 17 6. 5 Test sequences Use this menu to run demo-test sequences without an external controller, which will show you some possibilities of using the CitySource 96. 6.6 Stand-alone setting The fixtures on a data link are not connected to the controller…

9, CitySource 96 (Single colour) 9 To build a DMX chain 1. Connect the DMX output of the controller directly with the DMX input of the first fixture in the DMX chain. 2. Connect the DMX output of the first fixture in the DMX chain with the DMX input of the next fixture. 3. …

24, CitySource 96 (Single colour) 24 11. Cleaning and maintenance DANGER ! Disconnect from the mains before starting any cleaning or maintenance work Rinse off loose dirt with low pressure water spray. Wash the housing with a soft brush or sponge and a mild, non- abrasive…

7, CitySource 96 (Single colour) 7 You can install a frost foil under the eggcrate top hat to get frost light output. 1. Disconnect the fixture from the mains. 2. Uninstall the eggcrate lens module . 3. Place the frost foil (6) under the the eggcrate top hat (7) and secure i…

13, Robe CitySource 96 CitySource 96 (Single colour) 13 Menu Level 1 Menu Level 2 Menu Level 3 Menu Level 4 Menu Level 5 Menu Level 6 tEM.U. ° C , ° F LOAd FuLL EcO In.Po. dim1 0 - 255 : …