Hudson 1957 Technical Service Manual Supplement

35, TRANSMISSION—OVERDRIVE 33 REASSEMBLY When reassembling the transmission, always use new gaskets and oil seals. Reinstalling the Countershaft Gear and Shaft To hold the countershaft needle bearings, spacer, and washers in place while installing the countershaft gear, use a dummy sha…

7, ENGINE (V-8) 5 OIL SYSTEM Oil Pump Type Normal Oil Pressure Oil Pressure Release Engine Oil Refill Capacity Gear 10 Lbs. Min. Vii; 600 R.P.M. 55-60 Lbs. 5 Qts. TUNE-UP DATA Compression Pressure Cranking Speed (Throttle Wide Open) Engine Idle R.P.M. Standard and Over…

16, 14 FUEL—CARBURETION The accelerating pump circuit provides the measured amount of fuel necessary to insure smooth engine opera- tion during acceleration at speeds below approximately 30 MPH. When the throttle is closed, the pump plunger moves upward in its cylinder and fuel is draw…

37, Hudson 1957 TRANSMISSION—OVERDRIVE 35 Install the free wheeling cam snap ring on the main shaft. This snap ring is serviced in three different sizes .063", .068", and .073". Select the thickest ring which will fit into the retaining groove (Fig. 11). Proper selection of the sn…

42, Figure 3—Steering Knuckle Pin and Spindle Assembly Sequence Figure 3—Revision to Tool J-1374 or J-5566 40 FRONT SUSPENSION—STEERING FRONT WHEEL ALIGNMENT SPECIFICATIONS Turning Angle Inside Wheel Outside Wheel 25° 20-1/4° L/PS 21-3/4° W/PS Kingpin Angle 61/2° Caster Angle …