Vivitek DX864 series Operation & User’s Manual

74, Vivitek DX864 series – 65 – Resetting the Lamp After replacing the lamp, you should reset the lamp hour counter to zero. Refer to the following: 1. Press the MENU button to open the OSD menu. 2. Press the cursor ◄► button to move to the Installation II menu. Press the cursor button to move d…

43, — 34 — Network ITEM DESCRIPTION Network State Displays the network connection status. DHCP Press ◄► to turn DHCP On or Off. Note: If you select DHCP Off, complete the IP Address, Subnet Mask, Gateway, and DNS fields. IP Address Enter a valid IP …

78, – 69 – LED Error Messages ERROR CODE MESSAGES POWER LED GREEN LAMP LED RED TEMP LED RED Ready to power on (Standby) ON OFF OFF System Warm up Flash OFF OFF Lamp Lit , System stable ON OFF OFF Cooling Flashing OFF OFF Over Temper…

12, – 3 – Top view—On-screen Display (OSD) buttons and LEDs ITEM LABEL DESCRIPTION SEE PAGE: 1. MENU Opens and exits OSD menus 16 2. ▲ (Up cursor) / Keystone+ Navigates and changes settings in the OSD Quick Menu – For Keystone Under Media function: Navigates…

18, – 9 – Inserting the Remote Control Batteries 1. Remove the battery compartment cover by sliding the cover in the direction of the arrow. 2. Insert the battery with the positive side facing up. 3. Replace the cover. Caution: 1. Only use AAA bat…

89, — 80 — APPENDIX I RS-232C Protocol RS232 Setting Baud rate: 9600 Parity check: None Data bit: 8 Stop bit: 1 Flow Control None Minimum delay for next command: 1ms Control Command Structure P1 P2 Pin no. Name …