Wincor Nixdorf E1-CPU Operation & User’s Manual

84, 77 POST Code (Hex) Name Description 10h PM_INIT IF <power management enabled> THEN Set the power management configura- tion registers to default values. ENDIF 11h REG_INIT Set Cx5520 configuration registers to default values. Set any other configuration registers to default values. 12h RES…

19, 12 I/O Controller Hub This Hub provides extensive I/O support. Functions and capabilities include: PCI (33 MHz) support Enhanced DMA controller, Interrupt controller and Timer functions Integrated IDE controller supports Ultra ATA 100/66/33 USB host interface (3 UHCI Cont…

86, 79 POST Code (Hex) Name Description 3Ch ADV_CS_CONFIG IF <CMOS is valid (checksum good and battery good) THEN Load DRAM controller configuration registers with values from CMOS fields. ENDIF 3Dh ADV_REG_CONFIG IF <CMOS is valid> THEN Load ISA controller configuration registers with …

38, 31 LCD-TFT Adapter With a LCD-TFT adapter you can also connect the displays BA72A (12”) or BA73A (15”) via the 40pin ITDR-connector. If one of these displays is con- nected, the internal loudspeaker of the system must be disconnected! The connector is a 40 pin Mini Delta Ribbon connector, type …

67, Wincor Nixdorf E1-CPU 60 Main Menu System Time: [08:14:46] System Date: [07/14/2004] Legacy Diskette A: [1.44 MB 31/2“]  Primary Master [1090MB]  Primary Slave [None]  Secondary Master [None]  Secondary Slave [None] Extended Memory: 125 MB System Time [XX:XX:XX] Sets your system to the t…

40, 33 LAN 10/100 If a network adapter or controller board is installed, the system can be con- nected to a network (LAN 10/100 Mbit) from the POS terminal back panel. If a LAN adapter or controller board is not installed, this location on the back panel is closed by a dummy cover. The …