Pentek 7341 Installation Manual

13, Pentek 7341 Pentek Model 7341 Installation Manual Page 13 Rev.: B 2.2 Jumper Settings (continued) 2.2.2 Removing PMC Module from cPCI Carrier − Conduction Cooled 1) From the component side of the Model 7341−703 assembly (side with the PMC mounted), unscrew the four primary thermal interface…

22, Page 22 Pentek Model 7341 Installation Manual Rev.: B 2.7 Front Panel LEDs The 7141 PMC front panel has nine LED indicators, as illustrated in Figure 2−8. 2.7.1 Overload LEDs CH1 OV, CH2 OV There are two red overload LEDs, one for each A/D input, labeled CH1 OV and CH2 OV. Each LED is an i…

19, Pentek Model 7341 Installation Manual Page 19 Rev.: B 2.5 FPGA I/O Connections (continued) Table 2−2: Option 104 FPGA I/O Pin Connections FPGA Signal PMC P14 Pin cPCI J2 Pin FPGA Signal PMC P14 Pin cPCI J2 Pin LVDS_OUT_N0 1 Row E − 13 LVDS_OUT_N8 33 Row C − 7 LVDS_IN_N0 2 Row D …

1, Pentek Model 7341 Installation Manual Page 1 Manual Part No: 800.73410 Rev: B − November 20, 2009 Pentek, Inc. One Park Way Upper Saddle River, NJ 07458 (201) 818−5900 http://www.pentek.com Copyright © 2008−2009 INSTALLATION MANUAL MODEL 7341 Dual−Channel Multiband Transceiver 3U cPCI …

16, Page 16 Pentek Model 7341 Installation Manual Rev.: B 2.3 7141 PMC Module Jumpers An assembly drawing of the component side of the 7141 PCB is provided below, show− ing the jumper blocks and PMC connectors on the board. Jumper blocks JB1 and JB2 are for factory use only, except JB1 pins…