Watkiss PowerSquare 224 Operation & User’s Manual

23, 3 - The User Interface - The BASIC Window Watkiss PowerSquare™224 User Manual 19 - NUMBER Touch NUMBER to select how many times the form roller proc- esses the spine. The available options are 1, 2, 3 or 4. An increase in NUMBER increases the time taken to form the spine and can decrease…

55, 5 - Error Conditions, Problems and Solutions - Book Quality Problems Watkiss PowerSquare™224 User Manual 51 Damaged book Are there damage marks on the cover of the book near to the spine, from the form clamp, that are worse than the normal witness mark? No Yes Run a standard job using 80gsm/…

59, 5 - Error Conditions, Problems and Solutions - Message List Watkiss PowerSquare™224 User Manual 55 JAM AT STACKER OUTFEED There is a jam in the stacker out- feed or there are paper-trimmings in the stacker outfeed. Remove the books from the stacker out- feed. Check for paper-trimmings and …

39, Watkiss PowerSquare 224 4 - Standard Tasks - Adjust the Book Stacker Watkiss PowerSquare™224 User Manual 35 Adjust the Book Stacker Procedure 1. Before you use the Book Stacker, make sure the book support is pushed completely to the left. There is no need to empty the Book Stacker until the stacker is full. 2. …

98, 7 - Specifications - 94 Watkiss PowerSquare™224 User Manual Fore-Edge Trimming Maximum fore-edge trim: 28mm Minimum trimmed book size: 78mm Stacker Capacity Standard stacker: 35 books* Book Stacker (optional): 930mm Paper Input Requirements Input sheets must be of consistent siz…

2, © Watkiss Automation Limited 2013 All Rights Reserved. Reproduction, adaptation, or translation without prior written permission is prohibited, except as allowed under the copyright laws. Warranty The information contained in this document is subject to change without notice. Watkiss Autom…