Lexmark MS911 Quick Reference Manual

6, • Do not slide the paper into the tray. Load paper as shown in the illustration. • Make sure the guides in the tray or the multipurpose feeder are properly positioned and are not pressing tightly against the paper or envelopes. • Push the tray firmly into the printer after loading paper. Use …

15, 7 Push the cartridge holder into the finisher until the holder clicks into place. 8 Slide the finisher back into place. [x]‑page jam, open door H and rotate knob H6 clockwise. Leave paper in bin. [426.xx–428.xx] If the jammed paper is located under door G, then open the door and remove the p…

12, • Door J Note: If there is a jammed paper between the finisher bins, then remove the paper. • Areas H1 and H2 • Areas H3 and H4 • Area H6 5 Close Door H. 6 Open door C, and then remove the jammed paper. Note: Make sure that door C does not hit any cable attached to the printer. 12 …

14, [x]‑page jam, press latch to access area G and clear jammed staples. Leave paper in bin. [402.93] 1 Remove all paper from the staple finisher bin. 2 Press the latch on the staple finisher, and then slide the finisher to the left. 3 Remove the staple cartridge holder. 4 Use the metal tab…

1, Lexmark MS911 Quick Reference Learning about the printer Using the control panel Use the To 1 Display • Show the status of the printer. • Set up and operate the printer. 2 Home button Go to the home screen. 3 Sleep button Enable Sleep mode or Hibernate mode. The following actions wake the printer from…