Lexmark T650 Service Manual

348, 4-30 Service Manual 4062-XXX Go Back Previous Next LVPS card assembly removal (T652, T654, T656) WARNING: When replacing the LVPS card assembly, ensure that the voltage selection switch (E) is set to the proper setting, or damage will occur. 1. Remove the door assembly, rear. Go to “D…

115, Diagnostic information 2-79 4062 Go Back Previous Next 28x.68 x = bin number Staple ready home position jam Applies to: StapleSmart finisher The sensor (self priming) within the stapler assembly does not detect a ready staple prior to a staple job. Staples empty 1. Check all…

249, Diagnostic aids 3-43 4062-XXX Go Back Previous Next DEVICE TESTS Quick Disk Test This test performs a non-destructive read/write on one block per track on the disk. The test reads one block on each track, saves the data, and proceeds to write and read four test patterns to the byte…

110, 2-74 Service Manual 4062 Go Back Previous Next 28x.42 x = bin number Right tamper does not leave home position failure Applies to: StapleSmart finisher The sensor (right tamper HP) does not detect that the tamper has moved from home position. 1. Check all the connections on the output o…

131, Lexmark T650 Diagnostic information 2-95 4062 Go Back Previous Next 922.32 Fuser warm-up failure Fuser type = 2 The fuser hot roll does not reach operating temperature after increasing interpage gap. 1. Turn the machine off/on and ensure the fuser unit assembly is properly installed. 2. Ensur…

15, Notices and safety information xv 4062-XXX Go Back Previous Next Notices and safety information The following laser notice labels may be affixed to this printer. Laser notice The printer is certified in the U.S. to conform to the requirements of DHHS 21 CFR Subchapter J for Class I (1) …