Lexmark X862de Service Manual

717, Repair information 4-337 7500-432, -632, and -832 Go Back Previous Next Exit 2 sensor (standard bin full exit 2) removal 1. Remove the exit 2 unit assembly. See “Exit 2 unit assembly removal” on page 4-322. 2. Open the exit 2 unit assembly. 3. Remove the exit 2 left cover. See �…

568, 4-188 MFP Service Manual 7500-432, -632, and -832 Go Back Previous Next Document set actuator removal 1. Open the ADF left cover assembly. 2. Remove the ADF left cover media guide. See “ADF left cover media guide removal” on page 4-189. 3. Gently pry the document set actuator (A) from the AD…

430, 4-50 MFP Service Manual 7500-432, -632, and -832 Go Back Previous Next Pick roll idler gear 33 tooth removal 1. Remove the media tray. 2. Release the pick roll. See “Pick roll removal” on page 4-51. 3. Remove the pick roll drive gear - 25 tooth. See “Pick roll drive gear 25 tooth remova…

687, Repair information 4-307 7500-432, -632, and -832 Go Back Previous Next 8. Remove the spring (D) from the duplex wait actuator (E). 9. Turn the duplex wait in actuator (E) 180 degrees, and move it rightward and upward in the direction of the arrow. 10. Remove the duplex wait actuator (E). …

42, 1-18 MFP Service Manual 7500-432, -632, and -832 Go Back Previous Next Fuser Heat roll The heat roll is a hollow metal tube with a coated surface. This tube is heated by the inner heater lamp. The heat is applied to the media passing between the heat roll and pressure roll, fusing the toner …

808, Lexmark X862de 7-70 MFP Service Manual 7500-432, -632, and -832 Go Back Previous Next Assembly 34: 2000-sheet dual input (TTM)—feed and transport 2 1 3 6 5 4 …