KT&C Omni-ip Quick Operation Manual

24, Network Dome Camera·Quick Operation Guide 23 23 Figure 4-4 Install Plug-in (2) 6. Reopen the web browser after the installation of the plug-in and repeat steps 2-4 to login. For detailed instructions of further configuration, please refer to the user manual of network ca…

14, Network Dome Camera·Quick Operation Guide 13 13 If required, you can route cables through the side opening on the side of the mounting base. Figure 2-4 Side Opening 4. Loosen the tilt lock screws, adjust the tilting position in a range of 65 degrees, and tighten the t…

11, Network Dome Camera·Quick Operation Guide 10 10 2 Installation Before you start:  Make sure the device in the package is in good condition and all the assembly parts are included.  Make sure all the related equipment is power-off during the installation.  Check the spec…

12, KT&C Omni-ip Network Dome Camera·Quick Operation Guide 11 11 ● Make sure that there is no reflective surface too close to the camera lens. The IR light from the camera may reflect back into the lens causing reflection. ● The foam ring around the lens must be seated flush against the inner s…

22, Network Dome Camera·Quick Operation Guide 21 21 Figure 4-1 Login Interface 5. Install the plug-in before viewing the live video and managing the camera. Please follow the installation prompts to install the plug-in. You may have to close the web browser to finish the insta…