Magiglo Duo Power 2 Manual, User, Installation & Servicing Instructions

32, Magiglo Duo Power 2 Page 28 3.7.5. Freedom Surround Installation (if applicable) 1. Using Figure 44, mark out and create the appropriate opening in the wall at the desired height above the floor to accommodate the Freedom Surround. Figure 44 also includes details of the cut out in the outer wa…

24, Page 20 3.3.3. Physical Barrier Any physical barrier should meet the following requirements: 1. Provide at least the equivalent level of warning to the approach of an open fire, to that of a hearth. 2. Define a clear zone where occupants must exercise additional caution. 3. Shoul…

35, Page 31 3.7.9. Recessed Firebox Preparation On the inside wall: 1. Measure the height of the hearth and mark a horizontal line on the wall at the same height. 2. Above the hearth level draw a rectangle to the dimensions of the recess as detailed in Figure 49. Note that a lintel may…

21, Page 17 3.3. Appliance Location The fire must be fitted on a flat non-combustible base. In addition a non-combustible hearth or physical barrier with minimum dimensions shown in figures below should be provided in front of the fireplace opening where relevant. However, with hol…

27, Page 23 3.6. Contents Checklist Before proceeding with installation of the fire check the contents as follows: Carton 1 - Basic Kit Quantity Item 1 Gas Fire 1 Imitation Fuel – Coal ( NG/LPG ) or Pebble Set ( NG/LPG ) 1 Length of foam sealing strip 1 Isolat…

52, Page 48 4.4.1. Electrical Fault Finding Chart Electrical fault finding must be carried out by competent persons only. A suitable electrical test meter will be required for some of the tests listed. Switch on the Mains Power Supply at Isolating Switch START At fused spur, …