LulzBot Mini Quick Start Manual

20, 10b If you do not see filament coming through the nozzle and the drive gear stops moving, click the Extrude 10 button once more and wait. Repeat as needed until you see consistent and repeatable extrusion. 10c Wait ten seconds for the filament to cool, then remove the extruded �…

12, 7 Lower the Hinged Idler and Remove Loaded Filament STEP 7a Locate the tool head of your LulzBot Mini. Using the idler retainer, compress the springs with your thumb and slide up, allowing the hinged idler to move freely. Then lower the hinged idler counter-clockwise. Idler Reta…

9, 6 Control Your LulzBot Mini and Set the Temperature 6A Using your computer, click the Control button on the main Cura interface. A new window called the Printer Interface will open. STEP STEP 6 Continued... If the Control button does not appear, verify that that your software was fully insta…

10, 6b Using the Printer Interface window, raise the hot end temperature up to 240°C by typing 240 under “Temperature”, then clicking Set in the Printer Interface window. Monitor the current printer temperature using the status bar at the top of the Printer Interface window. Printer Inter…

24, LulzBot Mini 12 Remove Your 3D Printed Object STEP 12a After your LulzBot Mini is finished 3D printing, the hot end and print bed will automatically move into the cooling position (with the tool head in the top left and the print bed set back). Your printer is now actively cooling. Do not a…

13, 7b Wait until the status bar of the Printer Interface shows the Temperature has reached 240°C. 7c Once the Temperature has reached 240°C, pinch the HIPS filament loaded in the tool head and remove it by pulling up. HIPS Filament …